!- OSPF is configured to run on the !- Ethernet interface with an Area ID of 1. Note: In order to find additional information on the commands this document uses, refer to OSPF Commands or use the Command Lookup Tool ( registered customers only). This section presents you with information you can use in order to configure the features this document describes. Conventionsįor more information on document conventions, refer to the Cisco Technical Tips Conventions. You can also use this configuration with any two routers with at least one Ethernet, Token Ring, or FDDI interface. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration.
The information in this document was created from the devices in a specific lab environment. The information in this document applies to these software and hardware versions. Readers of this document should have knowledge of these topics: The command show ip ospf interface verifies that OSPF runs over all the broadcast media as broadcast network type by default. This document explains a sample configuration for Open Shortest Path First (OSPF) over the broadcast medium, such as Ethernet and Token Ring.
